How to Install LED Vanity Mirror Light bulbs 2019 Honda Passport
Table of Contents
How to Install Vanity Mirror Light bulbs 2019 Honda Passport with LED lights
Ready to upgrade your old halogen bulbs? Learn how to replace and complete the installation for LED headlight bulbs. Easy installation and tips!
The halogen interior bulbs may be too dim in your 2019 Honda Passport (2019-2023 Honda Passports) which can make vision difficult, especially in bad weather or severe driving conditions. Upgrading the old halogen bulbs on your Honda Passport with new aftermarket LED bulbs can add a great new look to your vehicle and improve visibility at night for a safer driving experience.
If you choose to upgrade your old halogen bulbs to new LED bulbs, it is best to confirm you have the correct replacement LED bulb by referring to the original bulb or the vehicle’s direct owner’s manual.
We will show you how to install your new ALLA Lighting LED bulbs for your vanity mirror light bulb.
Bulb sizes for the 2019 Honda Passport Vanity light bulb is # 6615F
Compatible Vehicles:
- 2019~2023 Honda Passport
Tools Needed for Installation:Â
- A flathead screwdriver
Step #1
Begin by flipping down the visor and flip up the vanity.
Step #2
There is a small gap at the bottom of the light, use your screwdriver to gently pry it free.
Step #3
Pull it down to remove the top tabs.
Step #4
Now use your screwdriver to pry out the incandescent bulb.
Step #5
Install the LEDs and rotate it so the LED chips face out.
Step #6
Slide the top of the lens in first then push in the bottom.
Step #7
Now repeat those steps for the other side.
Step #8
Pry out the bottom of the lens and pull it down.
Step #9
Pry out the incandescent bulb and replace it with the LED.
Step #10
Slide the top of the lens in first then push in the bottom.
The new LED bulbs are a huge upgrade from the incandescent bulbs bright and 6000k pure white.
Check out our Step by Step installation video!
Congratulations! Your LED Vanity Mirror Light Bulb installation is now complete in your 2019 Honda Passport. If you experienced any issues during your installation and unable to complete installation, please contact us for assistance. If the LED bulbs are experiencing hyper-flashing, flickering, an error code issues, then load resistors for this application will be required to be installed. These issues can occur due to the LEDs low current nature, which draws much less current than original stock halogen bulbs.
Please feel free to contact us at service@allalighting.com for assistance. Our team of highly trained representatives will be available to assist and provide the best solution. May also visit us at www.allalighting.comÂ
Looking for more LED upgrades for your vehicle. Check out the below bulb guide! For your reference only. All information below is not 100% guaranteed accurate. Please confirm the original bulb part numbers by referring to the original bulb or the vehicle’s direct owner’s manual prior to purchase.
VEHICLE INFORMATION
Front Exterior Lights
High Beam: Stock Bulb size # HB3/9005Â
Daytime Running Lightt: Stock Bulb size # LED
Fog Light: Stock Bulb size # LED
Front Turn Signal Light: Stock Bulb size # 7444NA
Front Side Marker Light: Stock Bulb size # LED
Rear Exterior Lights
Rear Turn Light: Stock Bulb size # 7440NA
Brake Light: Stock Bulb size # LED
Tail Light: Stock Bulb size # LED
Back-Up Reverse Light: Stock Bulb size # 7440
Center High Mount/ 3rd Brake Light: Stock Bulb size # LED
Vehicle Information Interior Lights
Certificated by
