Posted on 09/29/2023 by Alla Lighting
Ready to upgrade your old halogen bulbs? Learn how to replace and complete the installation for LED headlight bulbs. Easy installation and tips!
The halogen interior bulbs may be too dim in your 2019 Honda Passport, which can make vision difficult, especially in bad weather or severe driving conditions. Upgrading the old halogen bulbs on your 2019 Honda Passport with new aftermarket LED bulbs can add a great new look to your vehicle and improve visibility at night for a safer driving experience.
If you choose to upgrade your old halogen bulbs to new LED bulbs, it is best to confirm you have the correct replacement LED bulb by referring to the original bulb or the vehicle’s direct owner’s manual.
We will show you how to install your new ALLA Lighting LED bulbs for your map light application.
Bulb sizes for the 2019 Honda Passport map light bulb is # 168
The following installation steps can be used for 2019-2023 Honda Passport Map light application.
Pro Tip* Confirm stock bulb part number and use as reference to pick new LED bulbs*
Compatible Vehicles:
Tools Needed for Installation:Â
The following information is step by step instructions on how to install your new T10 2825 194 LED lights bulbs 12V SMD replacement for 168 158 194NAK OEM bulbs. Product used ALLA Lighting 194 1616-SMD See Item>Â https://allalighting.com/products/2825-194-led-lights-bulbs-12v-1616-smd-168-158-194nak
Start by pushing the on and off button of the light.
Hold it in and use your trim tool to pry out the end to remove the clips holding it in.
Here we highlight the clips and how they hold the lens in which will require to be aligned upon re-installation.
Pull out the incandescent bulb.
Install the LED bulb by pushing in the new bulb and testing it.Â
Replace the lens, line up the clips and push the lens in.
Repeat those steps for the other side.
Push in the on and off button and hold it. Use your trim tool to pry free the edge.
Pull out the incandescent bulb
Replace it with the LED bulb and then test it.
Replace the lens, line up the clips and then push it in until it clicks in place,
The new interior LED bulbs are great! Also a huge upgrade for the interior lights for this 2019 Honda Passport. Just see the difference. On the left is the new ALLA Lighting LED bulb and the right is the vehicle stock OEM bulb.Â
Check out our Step by Step installation video!
Congratulations! Your LED Map light installation is now complete in your 2019 Honda Passport. If you experienced any issues during your installation and unable to complete installation, please contact us for assistance. If the LED bulbs are experiencing hyper-flashing, flickering, an error code issues, then load resistors for this application will be required to be installed. These issues can occur due to the LEDs low current nature, which draws much less current than original stock halogen bulbs.
Please feel free to contact us at service@allalighting.com for assistance. Our team of highly trained representatives will be available to assist and provide the best solution. May also visit us at www.allalighting.comÂ
Looking for more LED upgrades for your vehicle. Check out the below bulb guide! For your reference only. All information below is not 100% guaranteed accurate. Please confirm the original bulb part numbers by referring to the original bulb or the vehicle’s direct owner’s manual prior to purchase.
High Beam: Stock Bulb size # HB3/9005Â
Daytime Running Lightt: Stock Bulb size # LED
Fog Light: Stock Bulb size # LED
Front Turn Signal Light: Stock Bulb size # 7444NA
Front Side Marker Light: Stock Bulb size # LED
Rear Turn Light: Stock Bulb size # 7440NA
Brake Light: Stock Bulb size # LED
Tail Light: Stock Bulb size # LED
Back-Up Reverse Light: Stock Bulb size # 7440
Center High Mount/ 3rd Brake Light: Stock Bulb size # LED
Vehicle Information Interior Lights
Category: Home, Honda Passport, How to Install