How to Install all new LED Dome Lights in a 2019 Honda Passport
Table of Contents
How to Install all New LED Dome Lights in a
2019 Honda Passport
Ready to upgrade your old halogen bulbs? Learn how to replace and complete the installation for LED headlight bulbs. Easy installation and tips!
The halogen interior bulbs may be too dim in your Honda Passport, which can make vision difficult, especially in bad weather or severe driving conditions. Upgrading the old halogen bulbs on your Honda Passport with new aftermarket LED bulbs can add a great new look to your vehicle and improve visibility at night for a safer driving experience.
If you choose to upgrade your old halogen bulbs to new LED bulbs, it is best to confirm you have the correct replacement LED bulb by referring to the original bulb or the vehicle’s direct owner’s manual.
We will show you how to install your new ALLA Lighting LED bulbs for your dome light application. The following is compatible for 2019-2023 Honda Passport Dome Light application. It is always recommended to confirm the stock bulb size by referencing the part number stamped on the stock bulbs.Â
Bulb sizes for the 2019 Honda Passport dome light bulb is #Â 168
Compatible Vehicles:
- 2019~2023 Honda Passport
Tools Needed for Installation:Â
- Trim Tool
The following information is step by step instructions on how to install your new T10 2825 194 LED lights bulbs 12V SMD replacement for 168 158 194NAK OEM bulbs in a 2019 Honda PassportÂ
Step #1
Start by pushing on the outside of the light.
Step #2
Use your trim tool to pry out the end and slide it to remove the clips holding it in.
Step #3
Pro Tip: Use some tape and wrap it around the incandescent bulb. This will allow a better grip.Â
Step #4
Pull on the tape to remove the bulb.
Step #5
Install the LED bulb and push in until locked in place.
Step #6
Repeat those steps for the other side.
Step #7
Push in the outside of the lens and then use your trim tool to pry the edge free.
Step #8
Wrap tape around the incandescent bulb and pull it out.
Step #9
Replace it with the LED bulb and then test it.
Step #10
Replace the lens sliding the outside first and then push it in until it clicks in place.
Step #11
Then repeat for the other lens.
The new LED bulbs are a huge upgrade for the interior lights for this Honda Passport. Just see the difference from a stock incandescent light (on the right) to the new LED bulbs from ALLA Lighting (on the left)Â
Check out our Step by Step installation video!
Congratulations! Your LED Dome light installation is now complete in your 2019 Honda Passport. If you experienced any issues during your installation and unable to complete installation, please contact us for assistance. If the LED bulbs are experiencing hyper-flashing, flickering, an error code issues, then load resistors for this application will be required to be installed. These issues can occur due to the LEDs low current nature, which draws much less current than original stock halogen bulbs.
Please feel free to contact us at service@allalighting.com for assistance. Our team of highly trained representatives will be available to assist and provide the best solution. May also visit us at www.allalighting.comÂ
Looking for more LED upgrades for your vehicle. Check out the below bulb guide! For your reference only. All information below is not 100% guaranteed accurate. Please confirm the original bulb part numbers by referring to the original bulb or the vehicle’s direct owner’s manual prior to purchase.
VEHICLE INFORMATIONÂ
Front Exterior Lights
High Beam: Stock Bulb size # HB3/9005Â
Daytime Running Lightt: Stock Bulb size # LED
Fog Light: Stock Bulb size # LED
Front Turn Signal Light: Stock Bulb size # 7444NA
Front Side Marker Light: Stock Bulb size # LED
Rear Exterior Lights
Rear Turn Light: Stock Bulb size # 7440NA
Brake Light: Stock Bulb size # LED
Tail Light: Stock Bulb size # LED
Back-Up Reverse Light: Stock Bulb size # 7440
Center High Mount/ 3rd Brake Light: Stock Bulb size # LED
Vehicle Information Interior Lights
Certificated by
