Posted on 12/07/2022 by Alla Lighting
Ready to upgrade your old halogen bulbs? Learn how to replace and complete the installation for LED brake light bulbs in your 2018 Ford Ecosport. Easy installation and tips!
Upgrading the old halogen bulbs on your 2018 Ford EcoSport with new aftermarket LED strobe bulbs can add a great new look to your vehicle and improve visibility at night for a safer driving experience.
If you choose to upgrade your old halogen bulbs to new LED bulbs, it is best to confirm you have the correct replacement LED bulb by referencing the original halogen bulb part number found in the OEM bulb or in the vehicle’s direct owner’s manual.
We will show you how to install your new ALLA Lighting LED bulbs in your low beam.
Bulb sizes for the 2018 Ford EcoSport brake light bulb is # :Â 7443
Compatible Vehicles:
Tools Needed for Installation:Â
The following information is step by step instructions on how to install your new 7440 7443 LED Strobe Brake Lights for a 2018 Ford Ecosport
Open the back hatch and on the side panel you’ll see an access panel for the light housing.
Open the access panel and pull it out to remove it
There are two plastics bolts you can unscrew with your fingers
Push the housing towards the back of the car from the inside
Remove the four phillips screws that holds in the socket housing
Pull up the housing to remove it from the posts
Pull out the incandescent bulbÂ
Install the LED bulb and test it
Slide the housing back together and replace the screws
 There are three sockets that will slide into the circle tabs
Push the housing back to front to slide it into place
Replace the two plastic bolts and replace de access panel
Now we repeat the same steps for the passenger side and the installation is complete
These strobe LED bulbs are pure red and very bright! Your LED Brake light is Now Complete!Â
Check out our Step by Step installation video!
Congratulations! Your LED Brake light installation is now complete in your 2018 Ford EcoSport. If you experienced any issues during your installation and unable to complete installation, please contact us for assistance. If the LED bulbs are experiencing hyper-flashing, flickering, an error code issues, then load resistors for this application will be required to be installed. These issues can occur due to the LEDs low current nature, which draws much less current than original stock halogen bulbs.
Please feel free to contact us at service@allalighting.com for assistance. Our team of highly trained representatives will be available to assist and provide the best solution. May also visit us at www.allalighting.comÂ
Looking for more LED upgrades for your vehicle. Check out the below bulb guide! For your reference only. All information below is not 100% guaranteed accurate. Please confirm the original bulb part numbers by referring to the original bulb or the vehicle’s direct owner’s manual prior to purchase.
High Beam: Stock Bulb size # HB3/9005Â
Daytime Running Lightt: Stock Bulb size # LED
Fog Light: Stock Bulb size # H8Â
Front Turn Signal Light: Stock Bulb size # 7444NA
Front Side Marker Light: Stock Bulb size # W5W/2825
Rear Turn Light: Stock Bulb size # 7440NA/WY21W
Brake Light: Stock Bulb size # 7443
Tail Light: Stock Bulb size # 7443
Back-Up Reverse Light: Stock Bulb size # 1156
Center High Mount/ 3rd Brake Light: Stock Bulb size # LED
Vehicle Information Interior Lights
Interior Dome Light: Â Stock Bulb # DE3175
Category: Ford Ecosport, Home, How to Install