Posted on 11/18/2022 by Alla Lighting
Ready to upgrade your old halogen bulbs? Learn how to replace and complete the installation for LED headlight bulbs. Easy installation and tips!
The halogen bulbs may be too dim in your Ford EcoSport, which can make forward vision difficult, especially in bad weather or severe driving conditions. Upgrading the old halogen bulbs on your Ford EcoSport with new aftermarket LED bulbs can add a great new look to your vehicle and improve visibility at night for a safer driving experience.
If you choose to upgrade your old halogen bulbs to new LED bulbs, it is best to confirm you have the correct replacement LED bulb by referencing the original halogen bulb part number found in the direct vehicle owner’s manual or directly on the bulb. original.
We will show you how to install your new ALLA Lighting LED bulbs in your low beam.
Bulb sizes for the 2018 Ford EcoSport low beam bulb is #H11
Compatible Vehicles:
Tools Needed for Installation:Â
The Following Information shows step by step the installation instructions on how to install your new H11 FL-BH LED Low Beam Headlights replacements in your Ford EcoSport 2018.
On the driver side, we’ll remove the fuse box cover to get more space to access the headlight bulb.Â
Â
Push the tab in, and pull the cover off.Â
Remove the dust cover off (The dust cover is pressure fit and can simply be removed by pulling on the rubber boot).
Turn the bulb counter clockwise to remove the bulb from the headlight housing.
Use you trim tool to pry open the locking tab to remove the wire connector
Plug in the LED bulb and test it.Â
This bulb is polarity sensitive, so if it doesn’t light up, unplug the bulb and rotate 180º degrees and plug it back in.
Line up the tabs on the bulb with the housing and insert the LED bulb
Rotate the bulb clockwise to lock it in place.
Rotate the bulb in the housing until the pigtail cord is facing down at the 6 o’clock position.
Fit the wires into the housing and replace the dust cover.
Replace the fuse box cover and push it down to lock it in place.
Now repeat the same steps on the passenger side.
If you can see a clean cut off line, it means both bulbs are installed correctly!Â
The LED bulbs will be much brighter, 6000 K xenon white LED bulbs will look amazing!
Check out our Step by Step installation video!
Congratulations! Your installation is now complete in your Ford EcoSport 2018. If you experienced any issues during your installation and unable to complete installation, please contact us for assistance. If the LED bulbs are experiencing hyper-flashing, flickering, an error code issues, then load resistors for this application will be required to be installed. These issues can occur due to the LEDs low current nature, which draws much less current than original stock halogen bulbs.
Please feel free to contact us at service@allalighting.com for assistance. Our team of highly trained representatives will be available to assist and provide the best solution. May also visit us at www.allalighting.comÂ
Looking for more LED upgrades for your vehicle. Check out the below bulb guide! For your reference only. All information below is not 100% guaranteed accurate. Please check original halogen bulb size before purchasing.Â
High Beam: Stock Bulb size # HB3/9005Â
Daytime Running Lightt: Stock Bulb size # LED
Fog Light: Stock Bulb size # H8Â
Front Turn Signal Light: Stock Bulb size # 7444NA
Front Side Marker Light: Stock Bulb size # W5W/2825
Rear Turn Light: Stock Bulb size # 7440NA/WY21W
Brake Light: Stock Bulb size # 7443
Tail Light: Stock Bulb size # 7443
Back-Up Reverse Light: Stock Bulb size # 1156
Center High Mount/ 3rd Brake Light: Stock Bulb size # LED
Vehicle Information Interior Lights
Interior Dome Light: Â Stock Bulb # DE3175
Category: Ford Ecosport, Home, How to Install