Posted on 04/26/2024 by Alla Lighting
Table of Contents
Introduction:
This blog will show you how to replace vanity mirror light bulbs on 2021 Dodge Charger
Compatible Vehicles:
2021 Dodge Charger
Tools Needed for Installation:Â
Trim tool
Flathead screwdriver
The Following Information shows simple step by step the installation instructions on how to install vanity mirror light bulbs to upgrade with all new led bulb from ALLA Lighting.Â
Pro Tip* Use a trim tool to pry the 4 holding clips (on on each side)Â
Pro Tip* Use the flathead screwdriver to remove the stock bulb if unable to remove. Use caution when removing.Â
Once the stock bulb is removed, install the LED bulb. The LED chips should face the lens (and not towards the vanity mirror assembly) Pro Tip* test the new LED bulb to ensure power connection.Â
Once you have tested the new LED bulb, put the lens back on until you hear the holding clips snap into place (there are 4 clips)Â
Congratulations!! Your installation for vanity mirror light is now complete in your 2021 Dodge Charger. If you experienced any issues during your installation and unable to complete installation, please contact us for assistance. If the LED bulbs are experiencing hyper-flashing, flickering, an error code issues, then load resistors for this application will be required to be installed. These issues commonly occur due to the LEDs low current nature which draws much less current than original stock halogen bulbs.
Please feel free to contact us at service@allalighting.com for assistance. Our team of highly trained representatives will be available to assist and provide best solution. May also visit us at www.allalighting.comÂ
Looking for more LED upgrades for your vehicle. Check out the below bulb guide! For your reference only. All information below is not 100% guaranteed accurate. Please check original halogen bulb size before purchasing.Â
High Beam and Low Beam: Stock Halogen Bulb size #9005 Recommended item>Â https://allalighting.com/products/hb3-9005-led-headlights-conversion-kits-bulbs-6500k-xenon-white
High Beam and Low Beam: Stock HID Bulb size # D3SÂ Recommended item>Â https://allalighting.com/products/d3s-d3r-led-headlights-bulbs-can-bus-hid-headlamps-change
Fog Light: Stock Bulb size # : LED (not replaceable with aftermarket LEDs)Â
Front Turn Signal Light: Stock Bulb size # : LEDÂ (not replaceable with aftermarket LEDs)Â
Front Side Marker Light: Stock Bulb size # : LEDÂ (not replaceable with aftermarket LEDs)Â
Rear Turn Light: Stock Bulb size # : LEDÂ (not replaceable with aftermarket LEDs)Â
Brake Light: Stock Bulb size # : LEDÂ (not replaceable with aftermarket LEDs)Â
Tail Light: Stock Bulb size # : LED (not replaceable with aftermarket LEDs)Â
Back-Up Reverse Light: Stock Bulb size # : LEDÂ (not replaceable with aftermarket LEDs)Â
Center High Mount/ 3rd Brake Light: Stock Bulb size # : LEDÂ (not replaceable with aftermarket LEDs)Â
License Plate Light: Â Stock Bulb size # : LEDÂ (not replaceable with aftermarket LEDs)Â
Interior Dome Light: Â Stock Bulb size # : 41MMÂ Â Recommended item>Â https://allalighting.com/products/41mm-211-2-578-led-festoon-bulbs-interior-lights-replacement-212-2
Interior Map Light: Â Stock Bulb size # : 41MMÂ Â Recommended item>Â https://allalighting.com/products/41mm-211-2-578-led-festoon-bulbs-interior-map-dome-trunk-lights
Interior Door Light Bulb: Stock Bulb size # :567Â Â Recommended item>Â https://allalighting.com/products/561-563-567-led-bulbs-festoon-rigid-loop-interior-lights-6000k-xenon-white
Trunk/Cargo Light: Â Stock Bulb size # : 567Â Recommended item>Â https://allalighting.com/products/561-563-567-led-bulbs-festoon-rigid-loop-interior-lights-6000k-xenon-white
Glove Box Light Bulb: Stock Bulb size # :194Â Recommended item>Â Â https://allalighting.com/products/194-175-led-bulbs-super-bright-12v-w5w-6k-white-interior-lights
Rear Reading Light Bulb: Stock Bulb size #194Â Recommended item>Â https://allalighting.com/products/w2-1-9-5d-base-t10-wedge-168-194-led-bulbs-interior-lights-replacement
Category: Bulb Guide, Dodge Charger, Home, How to Install
Subscribe now to keep reading and get access to the full archive.