Posted on 04/17/2026 by Alla Lighting
Table of Contents
Ready to upgrade your old halogen bulbs? Learn how to replace and complete the installation for LED light bulbs. Easy installation and tips!
The halogen interior bulbs may be too dim in your 2011-2023 Toyota Corolla, which can make vision difficult, especially in bad weather or severe driving conditions. Upgrading the old halogen bulbs on your 2011-2023 Toyota Corolla with new aftermarket LED bulbs can add a great new look to your vehicle and improve visibility at night for a safer driving experience.
If you choose to upgrade your old halogen bulbs to new LED bulbs, it is best to confirm you have the correct replacement LED bulb by referring to the original bulb or the vehicle’s direct owner’s manual.
We will show you how to install your new ALLA Lighting LED bulbs for your rear turn signal lights bulbs.
Bulb sizes for the 2011-2023 Toyota Corolla rear turn signal lights bulbs is # 7443
Begin by opening the trunk.
There’s a plastic cover we’ll need to remove first on the outside of the light housing.
Use your trim tool to pry the edges.
Then use your tool to push in the locking clips and pry free the one side.
Pull the cover out and then up to release the last tab.
We highlight here where the clips lock in.
Now use your wrench to remove the two bolts.
Push the housing from front to back to free the ball and socket joint from the car.
Turn the socket counterclockwise to remove it.
Pull out the incandescent bulb.
Replace it with the LED bulb and test it.
You can return the socket into the housing.
Line up the tabs on the socket with the housing.
Turn it clockwise to lock it.
Push the housing back to front to lock in the ball and socket joint.
Replace the two bolts and tighten.
Slide the bottom of the plastic cover in first.
Push the edges in until it locks in place.
Now we can repeat those same steps for the other side.
These super bright canbus turn signal LED bulbs look great and when we measure the output with our light meter is twice as bright as the incandescent bulb and these canbus bulbs are error free, with no flickering or hyperflashing.
Check out our Step by Step installation video!
RCongratulations! Your LED Rear Turn Signal Lights Bulbs installation is now complete in your 2011-2023 Toyota Corolla. If you experienced any issues during your installation and unable to complete installation, please contact us for assistance. If the LED bulbs are experiencing hyper-flashing, flickering, an error code issues, then load resistors for this application will be required to be installed. These issues can occur due to the LEDs low current nature, which draws much less current than original stock halogen bulbs.
Please feel free to contact us at service@allalighting.com for assistance. Our team of highly trained representatives will be available to assist and provide the best solution. May also visit us at www.allalighting.comÂ
Looking for more LED upgrades for your 2011-2023 Toyota Corolla. Check out the below bulb guide! For your reference only. All information below is not 100% guaranteed accurate. Please confirm the original bulb part numbers by referring to the original bulb or the vehicle’s direct owner’s manual prior to purchase.
High Beam: Stock Bulb size # HB3/9005Â
Daytime Running Lightt: Stock Bulb size # LED
Fog Light: Stock Bulb size # LED
Front Turn Signal Light: Stock Bulb size # 7444NA
Front Side Marker Light: Stock Bulb size # LED
Rear Turn Light: Stock Bulb size # 7440NA
Brake Light: Stock Bulb size # LED
Tail Light: Stock Bulb size # LED
Back-Up Reverse Light: Stock Bulb size # 7440
Center High Mount/ 3rd Brake Light: Stock Bulb size # LED
Vehicle Information Interior Lights
Category: Home
Subscribe now to keep reading and get access to the full archive.