Posted on 01/18/2023 by Alla Lighting
Ready to upgrade your old halogen bulbs? Learn how to replace and complete the installation for LED High beam headlight bulbs. Easy installation and tips!
Upgrading the old halogen bulbs on your Ford EcoSport with new aftermarket LED bulbs can add a great new look to your vehicle and improve visibility for a safer driving experience.
If you choose to upgrade your old halogen bulbs to new LED bulbs, it is best to confirm you have the correct replacement LED bulb by referencing the original halogen bulb part number found in the OEM bulb or in the vehicle’s direct owner’s manual.
We will show you how to install your new ALLA Lighting LED bulbs in your high beam headlight.
Bulb sizes for the 2018 Ford EcoSport high beam headlight bulb is # :HB3/9005Â Â
Compatible Vehicles:
The following information is step by step instructions on how to install your new HB3 / 9005 High Beam Headlight Bulbs.
We’ll begin under the hood. Reach under the hood and push the latch to the side to release it.
On the driver’s side, the high beam is right behind the headlight housing.
Peel off the dust cover.
Pry off the locking tab to remove the wire connector.
Turn the bulb clockwise to remove it.
Plug in the LED bulb and test it.Â
This bulb is polarity sensitive, so if it doesn’t light, unplug it and rotate the plug a 180º and plug it back in.
Line up the tabs on the bulb with the housing, the wire will be positioned to the side when installed.
Rotate the bulb counter clockwise to lock it. The wire on the bulb will be at the 12 o’clock position when locked.Â
Be sure the LED chips are orientated at the 3 o’clock and 9 o’clock position.
Feed the wires into the housing and replace the dust cover.
Now we’ll repeat the same steps on the passenger side.
When compared to the halogen bulb the LED is much brighter.Â
When we measured the output with the light meter the LED far exceeds the OEM bulb.Â
6000K xenon white LED bulbs look amazing!
Check out our Step by Step installation video!
Congratulations! Your installation is now complete in your Ford EcoSport 2018. If you experienced any issues during your installation and unable to complete installation, please contact us for assistance. If the LED bulbs are experiencing hyper-flashing, flickering, an error code issues, then load resistors for this application will be required to be installed. These issues can occur due to the LEDs low current nature, which draws much less current than original stock halogen bulbs.
Please feel free to contact us at service@allalighting.com for assistance. Our team of highly trained representatives will be available to assist and provide the best solution. May also visit us at www.allalighting.comÂ
Looking for more LED upgrades for your vehicle. Check out the below bulb guide! For your reference only. All information below is not 100% guaranteed accurate. Please confirm the original bulb part numbers by referring to the original bulb or the vehicle’s direct owner’s manual prior to purchase.
High Beam: Stock Bulb size # HB3/9005Â
Daytime Running Lightt: Stock Bulb size # LED
Fog Light: Stock Bulb size # H8Â
Front Turn Signal Light: Stock Bulb size # 7444NA
Front Side Marker Light: Stock Bulb size # W5W/2825
Rear Turn Light: Stock Bulb size # 7440NA/WY21W
Brake Light: Stock Bulb size # 7443
Tail Light: Stock Bulb size # 7443
Back-Up Reverse Light: Stock Bulb size # 1156
Center High Mount/ 3rd Brake Light: Stock Bulb size # LED
Vehicle Information Interior Lights
Interior Dome Light: Â Stock Bulb # DE3175
Category: Ford Ecosport, Home, How to Install