Posted on 12/26/2025 by Alla Lighting
Table of Contents
Ready to upgrade your old halogen bulbs? Learn how to replace and complete the installation for LED bulbs. Easy installation and tips!
The halogen exterior bulbs may be too dim in your 2018-2023 Chevrolet Equinox, which can make vision difficult, especially in bad weather or severe driving conditions. Upgrading the old halogen bulbs on your 2018-2023 Chevrolet Equinox with new aftermarket LED bulbs can add a great new look to your vehicle and improve visibility at night for a safer driving experience.
If you choose to upgrade your old halogen bulbs to new LED bulbs, it is best to confirm you have the correct replacement LED bulb by referring to the original bulb or 2018-2023 Chevrolet Equinox direct owner’s manual.
We will show you how to install your new ALLA Lighting LED bulbs for your License Plate Lights application.
Bulb sizes for the 2018-2023 Chevrolet Equinox License Plate Lights application is # 168
Tool Needed for Installation:Â
The following information is step by step instructions on how to install your new 2825 194 168 LED Bulbs replacements.
The license plate lights are located above the license plate.
Insert your trim tool into the slot on the inside edge of the housing.
Push it towards the outside, and pull it down.
Turn the socket counterclock wise to remove it.
Pull out the incandescent bulb.
Replace it with the LED, and test it.
Line up the tabs on the socket with the slots in the housing.
Install the socket back into the housing and turn it clockwise to lock it.
Slide the inside of the assembly first, then push it up into place.
Now repeat those steps on the other side.
Use your trim tool to push it towards the outside and pull it down.
Turn the socket counterclock wise to remove it.
Pull out the incandescent bulb.
Replace it with the LED and test it.
Line up the tabs on the socket with the slots in the housing.
Install the socket back into the housing, and turn it clockwise to lock it.
Slide the inside of the assembly first, then push it up into place.
Compared to the incandescent bulbs, these new LED bulbs are much brighter and look great for the license plate lights in 6000k white.
Check out our Step by Step installation video!
Congratulations! Your LED License Plate Lights Bulbs installation is now complete in your 2018-2023 Chevrolet Equinox. If you experienced any issues during your installation and unable to complete installation, please contact us for assistance. If the LED bulbs are experiencing hyper-flashing, flickering, an error code issues, then load resistors for this application will be required to be installed. These issues can occur due to the LEDs low current nature, which draws much less current than original stock halogen bulbs.
Please feel free to contact us at service@allalighting.com for assistance. Our team of highly trained representatives will be available to assist and provide the best solution. May also visit us at www.allalighting.comÂ
Looking for more LED upgrades for your 2018-2023 Chevrolet Equinox. Check out the below bulb guide! For your reference only. All information below is not 100% guaranteed accurate. Please confirm the original bulb part numbers by referring to the original bulb or the vehicle’s direct owner’s manual prior to purchase.
Front Exterior Lights
High Beam and Low Beam Headlight Bulb. Stock #: 9012 (HIR2) or D3S.
Front Fog Light Bulb. Stock #: H8.
Front Turn Signal Light Bulb. Stock #: 7443
Front Sidemarker Light Bulb. Stock #: 194
Rear Exterior Lights
Tail Light Bulb. Stock #: 194
Brake Light Bulb. Stock #: 7440
Rear Turn Signal Light Bulb. Stock #: 7440
Parking Light Bulb. Stock #: 7440
Back Up Light Bulb. Stock #: 921
License Plate Light Bulb. Stock #: 2825 (W5W)
Interior Lights
Luggage Compartment Light Bulb. Stock #: 194
Dome Light Bulb. Stock #: 194
Map Light Bulb. Stock #: 194
Vanity Mirror Light Bulb. Stock #: 6614F
Category: Home
Subscribe now to keep reading and get access to the full archive.