Table of Contents
2021 Dodge Charger How to replace Front Side Marker Assembly
Introduction:
This video will show you how to replace the front sidemarker assembly on a 2021 Dodge Charger. Please note, side marker assembly is not available at this time. Feel free to check out some of our other LED bulbs for other applications in your Dodge Charger.
Compatible Vehicles:
2021 Dodge Charger
Tools Needed for Installation:
T25 torx screwdriver
Trim tool
Bungee cord
The Following Information shows step by step the installation instructions on how to install/ replace front side market assembly in a 2021 Dodge Charger.
Step #1: Remove clips
The side market light is located in a specific spot. There are 3 clips holding the liner. Use the trim tool to remove all three clips
Step #2: Pull back the liner
Step #3: Remove T25 screws
Locate the two T25 screws and use the T25 screwdriver to remove both T25 screws.
Step #4: Pull out the light assembly
Pull out the light assembly and disconnect it from the light socket. Push the clip to unlock assembly from the socket.
Step #5: Reconnect the light harness to the light assembly
Step #6: Reinstall both T25 screws
Step #7: Release the bungee cord
Close the claw first for easier installation
Step #8: Reinstall the plastic clips
Push down the middle of the clip until you hear a snap
Check out Installation Video
Congratulations!! Your installation is now complete in your 2021 Dodge Charger. Please feel free to contact us at service@allalighting.com for assistance. Our team of highly trained representatives will be available to assist and provide best solution. May also visit us at www.allalighting.com
Looking for more LED upgrades for your vehicle. Check out the below bulb guide! For your reference only. All information below is not 100% guaranteed accurate. Please check original halogen bulb size before purchasing.
2021 Dodge Charger Vehicle Information Exterior Lights
High Beam and Low Beam with HID headlamps: Stock Bulb size # : D3 https://allalighting.com/products/d3s-d3r-led-headlights-bulbs-can-bus-hid-headlamps-change
High Beam and Low Beam with halogen headlamps: Stock Bulb size #: 9005 https://allalighting.com/products/ncp-9005-hb3-canbus-led-headlights-bulbs-dual-high-low-beam
Fog Light: Stock Bulb size # : LED (not compatible with aftermarket LED bulbs)
Front Turn Signal Light: Stock Bulb size # : LED (not compatible with aftermarket LED bulbs)
Front Side Marker Light: Stock Bulb size # : LED (not compatible with aftermarket LED bulbs)
Rear Turn Light: Stock Bulb size # : LED (not compatible with aftermarket LED bulbs)
Brake Light: Stock Bulb size # : LED (not compatible with aftermarket LED bulbs)
Tail Light: Stock Bulb size # : LED (not compatible with aftermarket LED bulbs)
Back-Up Reverse Light: Stock Bulb size # : LED (not compatible with aftermarket LED bulbs)
Center High Mount/ 3rd Brake Light: Stock Bulb size # : LED (not compatible with aftermarket LED bulbs)
License Plate Light: Stock Bulb size # : LED (not compatible with aftermarket LED bulbs)
Vehicle Information Interior Lights
Interior Dome Light: Stock Bulb size # : 42MM https://allalighting.com/products/41mm-211-2-578-led-festoon-bulbs-interior-map-dome-trunk-lights
Interior Map Light: Stock Bulb size # 41MM https://allalighting.com/products/41mm-211-2-578-led-festoon-bulbs-interior-lights-replacement-212-2
Interior Glove Box Light: Stock Bulb size #168 https://allalighting.com/products/t10-168-194-led-bulbs-license-plate-interior-map-dome-trunk-lights
Trunk/Cargo Light: Stock Bulb size # : 44MM https://allalighting.com/products/561-563-567-led-bulbs-festoon-rigid-loop-interior-lights-6000k-xenon-white
Interior Door Light: Stock Bulb size # : 44MM https://allalighting.com/products/561-563-567-led-bulbs-festoon-rigid-loop-interior-lights-6000k-xenon-white
Rear Reading Light: Stock Bulb size # :168 https://allalighting.com/products/w2-1-9-5d-base-t10-wedge-168-194-led-bulbs-interior-lights-replacement