Table of Contents
How to Replace 2020-2023 Nissan Sentra License Plate Light Assembly
Ready to upgrade your old halogen bulbs or need to replace your license plate light assembly? Learn how to replace and complete the installation for your 2020-2023 Nissan Sentra License Plate Light Assembly. In this article, we will be replacing with a new LED assembly. Easy installation and tips!
The halogen bulbs may be too dim in your 2020-2023 Nissan Sentra, which can make vision difficult, especially in bad weather or severe driving conditions. Upgrading the old halogen bulbs on your 2020-2023 Nissan Sentra with new aftermarket LED bulbs can add a great new look to your vehicle and improve visibility at night for a safer driving experience.
If you choose to upgrade your old halogen bulbs to new LED bulbs, it is best to confirm you have the correct replacement LED bulb by referring to the original bulb or the vehicle’s direct owner’s manual.
In this opportunity, we will show you how to install your new 2020-2023 Nissan Sentra LED License Plate Light Assembly.
Tools Needed for Installation:
- Trim Tool
Step #1
We’ll open the trunk to make it easier to work on.
Step #2
Insert your trim tool on the outside edge of the light assembly, push in and pry out that side.
Step #3
You can see how pushing in the clip allows you to pry it free.
Step #4
Remove the assembly and unplug the wire connector.
Step #5
We highlight here where it plugs in and how it fits into the car.
Step #6
Plug in the new assembly and install.
Step #7
Slide in the inside edge first and push up the outside edge to lock it.
Step #8
Now repeat those steps on the other side.
Step #9
On this side you’ll use your trim tool to pry free the inside edge.
Step #10
With the same technique push in the clip and pry it free.
Step #11
Plug the wire connector and plug in the new assembly.
Step #12
Slide in the outside edge first and then push it up to lock it.
Check out our Step by Step installation video!
Congratulations! Your new LED License Plate Light Assembly is now complete in your 2020-2023 Nissan Sentra. If you experienced any issues during your installation and unable to complete installation, please contact us for assistance. If the LED bulbs are experiencing hyper-flashing, flickering, an error code issues, then load resistors for this application will be required to be installed. These issues can occur due to the LEDs low current nature, which draws much less current than original stock halogen bulbs.
Please feel free to contact us at service@allalighting.com for assistance. Our team of highly trained representatives will be available to assist and provide the best solution. May also visit us at www.allalighting.com
Looking for more LED upgrades for your vehicle. Check out the below bulb guide! For your reference only. All information below is not 100% guaranteed accurate. Please confirm the original bulb part numbers by referring to the original bulb or the vehicle’s direct owner’s manual prior to purchase.
2022 Nissan Sentra VEHICLE INFORMATION
Front Exterior Lights
Front Fog Light Bulb. Stock #: LED
Front Sidemarker Light Bulb. Stock #: –
Front Turn Signal Light Bulb. Stock #: 3457NA (3457A)
High Beam and Low Beam Headlight Bulb. Stock #: LED
High Beam Headlight Bulb. Stock #: H9
Low Beam Headlight Bulb. Stock #: H11 (H11A)
Rear Exterior Lights
Back Up Light Bulb. Stock #: 921
Brake Light Bulb. Stock #: 7443
Parking Light Bulb. Stock #: 3457NA (3457A)
Rear Sidemarker Light Bulb. Stock #: 12961 (W5W)
Rear Turn Signal Light Bulb. Stock #: 7440NA (7440A)
Tail Light Bulb. Stock #: 7443
License Plate Light Bulb. Stock #: 168
Interior Lights
Dome Light Bulb. Stock #: DE3175
Glove Box Light Bulb. Stock #: T5
Trunk Light Bulb. Stock #: 194
Map Light Bulb. Stock #: 194