Table of Contents
How to Replace 2019-2023 Ford Ranger Mirror Puddle Lights Assembly.
Ready to upgrade your old halogen bulbs? Learn how to replace and complete the installation for LED headlight bulbs. Easy installation and tips!
The halogen exterior bulbs may be too dim in your 2019-2023 Ford Ranger, which can make vision difficult, especially in bad weather or severe driving conditions. Upgrading the old halogen bulbs on your 2019-2023 Ford Ranger with new aftermarket LED bulbs can add a great new look to your vehicle and improve visibility at night for a safer driving experience.
If you choose to upgrade your old halogen bulbs to new LED bulbs, it is best to confirm you have the correct replacement LED bulb by referring to the original bulb or the vehicle’s direct owner’s manual.
We will show you how to install your new LED bulbs for your 2019-2023 Ford Ranger Mirror Puddle Lights Assembly.
Tools Needed for Installation:
- Flathead screwdriver.
Step #1
Beginning under the side mirror, insert your screwdriver into the little slot on each side of the light.
Step #2
Pry the little tab on each side and pull it out.
Step #3
Pull the wire connector off the metal posts.
Step #4
Plug the wire connector onto the metal posts on the new assembly.
Step #5
You can see here how the larger tab will install into the larger slot and the smaller tab will go into the smaller slot.
Step #6
Install the smaller tab first then push it up into place.
Step #7
Now repeat those steps for the other side.
Step #8
Insert your screwdriver into the little slots on each side of the light.
Step #9
Pry the little tabs on each side and pull it out.
Step #10
Pull the wire connector off the metal posts.
Step #11
Plug the wire connector onto the metal posts on the new assembly.
Step #12
Install the smaller clip first, then push it up into place.
These new LED bulbs in the Mirror Puddle Lights Assembly looks great on your 2019-2023 Ford Ranger and are a huge improvement.
Check out our Step by Step installation video!
Congratulations! Your LED Mirror Puddle Lights Assembly installation is now complete in your 2019-2023 Ford Ranger. If you experienced any issues during your installation and were unable to complete the installation, please contact us for assistance. If the LED bulbs are experiencing hyper-flashing, flickering, or error code issues, then load resistors for this application will be required to be installed. These issues can occur due to the LEDs low current nature, which draws much less current than the original stock halogen bulbs.
Please feel free to contact us at service@allalighting.com for assistance. Our team of highly trained representatives will be available to assist and provide the best solution. May also visit us at www.allalighting.com
Looking for more LED upgrades for your 2019-2023 Ford Ranger. Check out the below bulb guide! For your reference only. All information below is not 100% guaranteed accurate. Please confirm the original bulb part numbers by referring to the original bulb or the 2019-2023 Ford Ranger‘s direct owner’s manual prior to purchase.
2019-2023 Ford Ranger Vehicle Information
Front Exterior Lights
High Beam Headlight Bulb. Stock #: 9005 (HB3)
Low Beam Headlight Bulb. Stock #: H11 (H11A)
Front Fog Light Bulb. Stock #: H11 (H11A), LED
Front Turn Signal Light Bulb. Stock #: 7443
Front Sidemarker Light Bulb. Stock #: 194
Rear Exterior Lights
Parking Light Bulb. Stock #: 3157
Tail Light Bulb. Stock #: 7443, 3157
Rear Turn Signal Light Bulb. Stock #: 3157
Center High Mount Stop Light Bulb. Stock #: 912
License Plate Light Bulb. Stock #: 2825 (W5W)
Back Up Light Bulb. Stock #: 3157, 7440
Brake Light Bulb. Stock #: 3157
Interior Lights
Luggage Compartment Light Bulb. Stock #: 912