Table of Contents
How to Install 2019-2023 Ford Ranger Front Turn Signal Light Bulbs.
Ready to upgrade your old halogen bulbs? Learn how to replace and complete the installation for LED headlight bulbs. Easy installation and tips!
The halogen exterior bulbs may be too dim in your 2019-2023 Ford Ranger, which can make vision difficult, especially in bad weather or severe driving conditions. Upgrading the old halogen bulbs on your 2019-2023 Ford Ranger with new aftermarket LED bulbs can add a great new look to your vehicle and improve visibility at night for a safer driving experience.
If you choose to upgrade your old halogen bulbs to new LED bulbs, it is best to confirm you have the correct replacement LED bulb by referring to the original bulb or the vehicle’s direct owner’s manual.
We will show you how to install your new ALLA Lighting LED bulbs for your Front Turn Signal Lights application.
Bulb sizes for the 2019-2023 Ford Ranger Front Turn Signal Light Bulbs is # 7443
The following information is step by step instructions on how to install your new Can Bus T20 7440 7443 LED Bulbs Amber Yellow Turn Signal Lights LED Bulbs replacements.
Step #1
We’ll begin under the hood.
Step #2
Behind the headlight housing you can access the turn signal socket.
Step #3
Turn the socket counterclockwise to remove it.
Step #4
Pull out the incandescent bulb.
Step #5
Replace it with the LED bulb and test it.
Step #6
Line up the notches on the socket with the slots in the housing.
Step #7
Insert the socket and turn it clockwise to lock it.
Step #8
We can now repeat those steps on the other side.
Step #9
Turn the socket counterclockwise to remove it.
Step #10
Pull out the incandescent bulb.
Step #11
Replace it with the LED bulb and test it.
Step #12
Line up the notches on the socket with the slots in the housing.
Step #13
Insert the socket and turn it clockwise to lock it.
These new yellow LED turn signal bulbs are super bright and they look amazing and these canbus bulbs are error free with no flickering or hyper flashing.
Check out our Step by Step installation video!
Congratulations! Your LED Front Turn Signal Light Bulb’s installation is now complete in your 2019-2023 Ford Ranger. If you experienced any issues during your installation and unable to complete installation, please contact us for assistance. If the LED bulbs are experiencing hyper-flashing, flickering, an error code issues, then load resistors for this application will be required to be installed. These issues can occur due to the LEDs low current nature, which draws much less current than original stock halogen bulbs.
Please feel free to contact us at service@allalighting.com for assistance. Our team of highly trained representatives will be available to assist and provide the best solution. May also visit us at www.allalighting.com
Looking for more LED upgrades for your vehicle. Check out the below bulb guide! For your reference only. All information below is not 100% guaranteed accurate. Please confirm the original bulb part numbers by referring to the original bulb or the vehicle’s direct owner’s manual prior to purchase.
2019-2023 Ford Ranger Vehicle Information
Front Exterior Lights
High Beam Headlight Bulb. Stock #: 9005 (HB3)
Low Beam Headlight Bulb. Stock #: H11 (H11A)
Front Fog Light Bulb. Stock #: H11 (H11A), LED
Front Turn Signal Light Bulb. Stock #: 7443
Front Sidemarker Light Bulb. Stock #: 194
Rear Exterior Lights
Parking Light Bulb. Stock #: 3157
Tail Light Bulb. Stock #: 7443, 3157
Rear Turn Signal Light Bulb. Stock #: 3157
Center High Mount Stop Light Bulb. Stock #: 912
License Plate Light Bulb. Stock #: 2825 (W5W)
Back Up Light Bulb. Stock #: 3157, 7440
Brake Light Bulb. Stock #: 3157
Interior Lights
Luggage Compartment Light Bulb. Stock #: 912