Table of Contents
How to install your new LED 7440NA amber yellow Rear Turn Signal Lights Bulbs in a 2018 Ford Eco Sport?
Ready to upgrade your old halogen bulbs? Learn how to replace and complete the installation for LED Rear Turn Signal Lights Bulbs in your 2018 Ford EcoSport. Easy installation and tips!
Upgrading the old halogen bulbs on your 2018 Ford EcoSport with new aftermarket LED can bus bulbs can add a great new look to your vehicle and improve visibility at night for a safer driving experience.
If you choose to upgrade your old halogen bulbs to new LED bulbs, it is best to confirm you have the correct replacement LED bulb by referencing the original halogen bulb part number found in the OEM bulb or in the vehicle’s direct owner’s manual.
We will show you how to install your new ALLA Lighting LED bulbs in your Rear Turn Signal Lights.
Bulb sizes for the 2018 Ford EcoSport Rear Turn Signal light bulb is #: 7440
Bulb size for a 2018 Ford EcoSport Brake Light bulb is# : 7443
Compatible Vehicles:
- 2018 Ford EcoSport
Tools Needed for Installation:
- T25 Torx Screwdriver
- Phillips Screwdriver
The following information is step by step instructions on how to install your new CAN Bus T20 7440 7443 LED Bulbs Amber Yellow Turn Signal Lights for a 2018 Ford Ecosport
Step #1
Open the back hatch and on the side panel you’ll see an access panel for the light housing.
Step #2
Open the access panel and pull it out to remove it
Step #3
There are two plastics bolts you can unscrew with your fingers
Step #4
Push the housing towards the back of the car from the inside
Step #5
Remove the four phillips screws that holds in the socket housing
Step #6
Pull up the housing to remove it from the posts
Step #7
Pull out the incandescent bulb
Step #8
Install the LED bulb and test it
Step #9
Slide the housing back together and replace the screws
Step #10
There are three sockets that will slide into the circle tabs
Step #11
Push the housing back to front to slide it into place
Step #12
Replace the two plastic bolts and replace de access panel
Step #13
Now we repeat the same steps for the passenger side and the installation is complete
The yellow LED bulbs are a huge upgrade from the incandescent and this new LED turn signal bulb is CAN-bus with no error code, flickering or hyperflashing.
All new 7440 CANBUS LED TURN SIGNAL LED BULBS for your 2018 Ford Ecosport
Check out our Step by Step installation video!
Congratulations! Your LED Brake light installation is now complete in your 2018 Ford EcoSport. If you experienced any issues during your installation and unable to complete installation, please contact us for assistance. If the LED bulbs are experiencing hyper-flashing, flickering, an error code issues, then load resistors for this application will be required to be installed. These issues can occur due to the LEDs low current nature, which draws much less current than original stock halogen bulbs.
Please feel free to contact us at service@allalighting.com for assistance. Our team of highly trained representatives will be available to assist and provide the best solution. May also visit us at www.allalighting.com
Looking for more LED upgrades for your vehicle. Check out the below bulb guide! For your reference only. All information below is not 100% guaranteed accurate. Please confirm the original bulb part numbers by referring to the original bulb or the vehicle’s direct owner’s manual prior to purchase.
Vehicle Information Exterior Lights
High Beam: Stock Bulb size # HB3/9005
Daytime Running Lightt: Stock Bulb size # LED
Fog Light: Stock Bulb size # H8
Front Turn Signal Light: Stock Bulb size # 7444NA
Front Side Marker Light: Stock Bulb size # W5W/2825
Rear Turn Light: Stock Bulb size # 7440NA/WY21W
Brake Light: Stock Bulb size # 7443
Tail Light: Stock Bulb size # 7443
Back-Up Reverse Light: Stock Bulb size # 1156
Center High Mount/ 3rd Brake Light: Stock Bulb size # LED
Vehicle Information Interior Lights
Interior Dome Light: Stock Bulb # DE3175