Table of Contents
How to Install 2011-2022 Jeep Compass Front Turn Signal Lights Bulbs
Ready to upgrade your old halogen bulbs? Learn how to replace and complete the installation for LED light bulbs. Easy installation and tips!
The halogen exterior bulbs may be too dim in your 2011-2022 Jeep Compass, which can make vision difficult, especially in bad weather or severe driving conditions. Upgrading the old halogen bulbs on your 2011-2022 Jeep Compass with new aftermarket LED bulbs can add a great new look to your vehicle and improve visibility at night for a safer driving experience.
If you choose to upgrade your old halogen bulbs to new LED bulbs, it is best to confirm you have the correct replacement LED bulb by referring to the original bulb or the vehicle’s direct owner’s manual. We will show you how to install your new ALLA Lighting LED bulbs for your Front Turn Signal Lights Bulbs.
Bulb sizes for the 2011-2022 Jeep Compass Front Turn Signal Lights Bulbs is # 7443
The following information is step-by-step instructions on how to install your new LED Can Bus T20 7440 7443 LED Bulbs Amber Yellow Turn Signal Lights Replacement
For this installation, you’ll need:
- A 5/16 wrench
Step #1
We’ll begin in the driver side wheel well.
Step #2
Start by unscrewing the four bolts in the fender liner.
Step #3
Peel back the liner to access the turn signal bolts.
Step #4
Remove the bulb by turning the socket counterclockwise and pull the bulb from the socket.
Step #5
Pull the incandescent bulb out.
Step #6
Replace with the LED bulb and test it.
Step #7
Insert the bulb back into the housing and turn the socket clockwise to lock it.
Step #8
Tuck the fender liner back in and replace the four bolts.
Step #9
Now we’ll repeat the same steps on the passenger side.
Step #10
Start by removing the four bolts.
Step #11
Peel the fender liner back and unlock the turn signal socket by turning it counterclockwise.
Step #12
Put the bulb back into the housing and lock it by turning clockwise.
Step #13
Replace the fender liner and the four bolts.
These new LED bulbs are canbus error-free with no flickering or hyper flashing. And they are much brighter than the stock incandescent bulbs.
Check out our Step by Step installation video!
Congratulations! Your LED Front Turn Signal Lights Bulbs Installation is now complete in your 2011-2022 Jeep Compass. If you experienced any issues during your installation and unable to complete installation, please contact us for assistance. If the LED bulbs are experiencing hyper-flashing, flickering, an error code issues, then load resistors for this application will be required to be installed. These issues can occur due to the LEDs low current nature, which draws much less current than original stock halogen bulbs.
Please feel free to contact us at service@allalighting.com for assistance. Our team of highly trained representatives will be available to assist and provide the best solution. May also visit us at www.allalighting.com
Looking for more LED upgrades for your 2011-2022 Jeep Compass? Check out the below bulb guide! For your reference only. All information below is not 100% guaranteed accurate. Please confirm the original bulb part numbers by referring to the original bulb or the vehicle’s direct owner’s manual prior to purchase.
Vehicle Information
Front Exterior Lights
Low Beam Headlight Bulb: Stock #: H11 (H11A)
High Beam Headlight Bulb: Stock #: 9005 (HB3)
High Beam and Low Beam with HID Headlamps: Stock #: HID-D3S
Front Fog Light Bulb: Stock #: H11 (H11A)
Daytime Running Light: Stock #: 2504
Front Turn Signal Light: Stock #: 7443
Rear Exterior Lights
Back Up Light Bulb: Stock #: 7440
Rear Turn Signal Light Bulb: Stock #: 7440, 7443.
Brake Light Bulb. Stock #: 7443, LED
Tail Light Bulb. Stock #: 7443, LED
Interior Lights
Map Light Bulb: Stock #: 168
Dome Light Bulb: Stock #: 6418
Luggage Compartment Light Bulb: Stock #: 6418
Vanity Mirror Light Bulb: Stock #: 6418